Scarva Liquid Metals & Lustres Platinum From £26.47


Code de produitCode de la pièceNiveau des stocksGrandeur/CouleurPricePanierFavoris
22733LML10/2GDisponible2g
£26.47
Buy
Ajoutez à la liste de favoris
22734LML10/5GDisponible5g
£44.15
RRP £64.80
Sauver 32%
Buy
Ajoutez à la liste de favoris
22735LML10/10GDisponible10g
£86.71
RRP £129.62
Sauver 33%
Buy
Ajoutez à la liste de favoris
22736LML10/25GDisponible25g
£195.05
RRP £324.03
Sauver 40%
Buy
Ajoutez à la liste de favoris
22737LML10/50GDisponible50g
£351.10
RRP £648.10
Sauver 46%
Buy
Ajoutez à la liste de favoris
Postage to United Kingdom on this item starts at £5.50
  • Description
  • Comptes rendus (2)
Scarva Liquid Metals & Lustres Logo

Firing temperature: 700-800°C
Set the controller for 100° per hour - no soak
Liquid precious metals are supplied ready for use. Further thinning is not recommended. The bottle should not be shaken deliberately and it is essential that bottle lips should be clean before pouring.

For most purposes, liquid precious metals are supplied to the correct viscosity, however, this increases on exposure to air, particularly under warm or dry conditions. It is inadvisable to pour out more liquid precious metal than is required for 30 minutes continuous work. This may vary depending on the atmospheric conditions in the decorating shop. When painting moulded surfaces such as figurines, it may be advantageous to allow the liquid precious metal to become rather more viscous than for lining or banding, otherwise it may tend to drain away from protruding areas and collect in the crevices. If through exposure to air, the liquid precious metal becomes too viscous and tacky, its original painting properties may be restored by working in very thoroughly, one or two drops of Lustre Thinners.

Good quality brushes should be used and these are available in various shapes and sizes according to use, either for lining, banding or tracing. Brushes used exclusively for liquid precious metals should be kept separate, clean and free from dust. After use they should be cleaned with Lustre Thinners. To prepare the brush for painting, it should be dipped into the liquid precious metal and worked on a smooth piece of glass or glazed ceramic tile until it is saturated. The brush should then be passed lightly over the surface in order to remove excess liquid precious metal and the hairs brought to a fine point in the case of a lining brush, or to a smooth edge for a banding brush.

Signal Word: Warning

Hazard Statements
H226 Flammable liquid and vapour.
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.

Precautionary Statements
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P271 Use only outdoors or in a well-ventilated area.
P270 Do not eat, drink or smoke when using this product.
P262 Do not get in eyes, on skin, or on clothing.
P308+P313 IF exposed or concerned: Get medical advice/attention.
P501 Dispose of contents/container in accordance with national regulations.

Aussi acheté